2" 50mm Felt with Cerium Oxide and Glass Polishing Compound for Glass and Perspex Polishing. With an M14 threade hook and loop backing pad.
This DIY kit is a very cost effective solution for repairs to fish tanks, car glass, windscreens and all other glass products. Kit contains enough consumables for more than one repair.
Best quality High resistant Rayon fiber ensures high gloss finish on various surfaces such as Minerals, Plastics, glass and coatings.
Resin impregnated to one side to give faster cutting action and quality finish.
Bonded fibres ensure no loose particals to contaminate your surface.
Using this kit:
Mix approximately 40-45grams of Cerium oxide powder into 50ml water to a form a thin paste like slurry eg. milk-like consistency, in the bottle provided which can be used to apply to your polishing pad
Clean the glass surface removing all dirt, grease and residue
Apply the polishing compound mixture to the polishing pad or glass surface
Make sure to mark the inside of the glass with the crayon to identify the area you are working on
With the mounted pad in the drill begin working the area required.
Move the pad up and down, left and right in even movements on the work area.
Keep the surface cool and wet to prevent the glass getting too hot. (Very Important!!)
Inspect the work area by wiping off the residue and keep working until the area is satisfactorily polished.
Use the Glass polishing compound with an un-used polishing pad over the plished are to complete the process.
On completion wash and store your polishing pads to use again on your next project.